Instructions / Assembly

4 » Adjust the length of cord (H) to achieve the desired
height of the mounted fixture.
1) Use Allen wrench (M) to unscrew the screw in strain
relief (F), carefully pull and push cord (H) through
canopy (E) and strain relief (F) to lengthen or shorten
the length of cord (H).
2) Once the desired height of fixture is achieved,
carefully tighten the screw till snug.
NOTE: To prevent cord (H) from slipping out of
canopy (E), make an overhand knot of cord (H).
5 » If needed, shorten the extra length of the fixture wires
from cord (H) so that they all are at least 6 inches
(152.4 mm) long above canopy (E) within the outlet box.
6 » Carefully pass supply wires through mounting plate
assembly (A).
Secure mounting plate assembly (A) to the outlet box
with mounting screws (D).
NOTE: the side of mounting plate assembly (A)
marked "GND" must face out.
7 » Make wire connections
Connect wires as below wires connection shown. REFER TO THE FOLLOWING CHARTS, NEVER CONNECT
OTHER WIRES TO GROUND WIRES.
Connect ground wires according to the below chart Connect wires according to the below chart
Connect Black or Connect
A B
Red Supply Wire to: White Supply Wire to:
Black White
OUTLET BOX
GROUND
OUTLET BOX
GROUND
*Parallel cord (round & smooth) *Parallel cord (square & ridged)
Clear, Brown, Gold or Black with
FIXTURE
GROUND
FIXTURE
GROUND
Clear, Brown, Gold or Black without
tracer tracer
Insulated wire(other than green)
Insulated wire(other than green)
with copper conductor
with silver conductor
CUPPED
WASHER
* Note: When parallel wires (SPT I&
DIMPLES
SPT ll) are used. The neutral wire is
square shaped or ridged and the
other wire will be round in shape or
smooth (see illus.)
GREEN GROUND
SCREW
GREEN GROUND
SCREW
Neutral Wire
Page: - 3 - / 4
[e-mail]