Instructions / Assembly

Page: - 3 - / 3
[e-mail]
Step A2: Secure mounting plate (D) to the outlet box with mounting screws (A).
Step A3: Make wire connections
Connect wires as below wires connection shown.
PLEASE NOTE THAT GROUND WIRE IS BARE COPPER WIRE, NEVER CONNECT OTHER WIRES
TO GROUND WIRES.
Connect ground wires according to the below chart Connect wires according to the below chart
Twist wires together with plastic wire connectors until tightly joined, and wrap each connector with approved
electrical tape. Be sure that no wire strands are exposed and then carefully tuck all wires into the outlet box.
Step A4: Align the holes in back plate (E) with the pre-assembled mounting screws, then attach back plate (E) using
the previously removed ball knobs (F). Hand tighten until snug.
Step A5: Install bulbs (Not included) (Please do not exceed the maximum wattage recommended on the
socket.)
Screw jars (I) onto lids (H) till snug.
4. Check everything is installed properly, then you could turn on the light. Enjoy!
CLEANING
To clean, wipe the fixture with a soft cloth. Clean glass with a mild cleaner (such as mild and non-abrasive soap.) Do
not use abrasive materials such as scouring pads or powders, steel wool or abrasive paper.
ORDERING PARTS
Keep this sheet for future reference in case you need to order replacement parts. All parts for this fixture can be ordered
from the place of purchase. Be sure to use exact wording from illustration when ordering parts.