Instructions / Assembly

  Weareheretohelp:[e-mail]
www.lnchome.comPage:  ‐5‐/5
7) Install bulb (Not included. Please do not exceed the maximum capacity recommended on the
socket.)
Adjust the fixture to desired direction through unscrewing
the stud(G). Once the desired direction achieved, tighten the stud (G).



4.
Checkeverythingisalreadyinstalledproperly,thenyoucouldturnonthelight. 
Ifyouwouldconnecttheattachedpowercordontothebackplateoffixtureforextensionuse


StepA1:Passthepowercordthroughtheholeinbackplate  
StepA2:Lacethepowercordthroughthestrainrelief:
Passthepowercordthroughthelowerholeinstrainrelief,thentwistthecordtotheinversionand 
passthepowercordthroughtheupperholeinstrainrelief.Gentlypullthepowercorduntiltight.
StepA3:Refertheabovementioned“5)Makewireconnections”forproperwireconnections

CLEANING 
Toclean,wipefixturewithasoftcloth.Donotuseabrasivematerialssuchasscouringpadsorpowders,steel
woolorabrasivepaper. 

ORDERINGPARTS 
Keepthissheetforfuturereference,andincaseyouneedtoorderreplacementparts.Allpartsforthisfixturecan
beorderedfromplaceofpurchase.Besuretouseexactwordingfromillustrationwhenorderingparts.