Instructions / Assembly

Page: - 3 - / 3
Step A1: Unscrew screws (F) from back plate (E) then gently remove mounting plate (C). Then set them aside for later
installation.
Step A2: Carefully pass the supply wires from the outlet box through mounting plate (C).
Attach mounting plate (C) to the outlet box with mounting screws (B).
Step A3: Make wire connections
Connect wires as below wires connection shown. PLEASE NOTE THAT GROUND WIRE IS BARE COPPER WIRE,
NEVER CONNECT OTHER WIRES TO GROUND WIRES.
Connect ground wires according to the below chart Connect wires according to the below chart
Twist wires together with plastic wire connectors until tightly joined, and wrap each connector with
approved electrical tape. Be sure that no wire strands are exposed and then carefully tuck all wires into
the outlet box.
Step A4: Position back plate (E) and mounting plate (C) in place, carefully thread screws (F) through the holes in back
plate (E) and mounting plate (C). Secure them by tightening screws (F).
Step A5: Fix glasses (H) to sockets (I) with socket rings (G).
Install bulbs (Not included) (Please do not exceed the maximum wattage recommended on the socket.)
4. Check everything is installed properly, then you could turn on the light. Enjoy!
CLEANING
To clean, wipe the fixture with a soft cloth. Do not use abrasive materials such as scouring pads or powders,
steel wool or abrasive paper.
ORDERING PARTS
Keep this sheet for future reference in case you need to order replacement parts. All parts for this fixture can
be ordered from the place of purchase. Be sure to use exact wording from illustration when ordering parts.
[e-mail]