Instructions / Assembly

Item Number: A03355

WARNING (To reduce the risk of fire, electric shock, or injury to persons):

1. We suggest installation by a licensed electrician.

2. Please read the instruction carefully and save it as you may need it at later time.

3. Before you start, NEVER attempt any work without shutting off the electricity until the work is done. A). Go to the

main fuse, or circuit breaker, box in your home. Place the main power switch in the “OFF” position. B). Place the wall

switch in the “OFF” position.

4. Mounting surface should be clean, flat, strong enough and 1/4” larger than the canopy on all side. Any gaps between

the mounting surface and canopy exceeding 3/16” should be corrected as required.

5. Make sure that the ceiling or wall can stand the weight of the lamp before fixture.

6. Make sure the voltage you are using is 120V. The maximum wattage is 60W per bulb.

7. Keep the lamp away from acidic and basic objects in case of damaging the surface of the lamp.

8. When replacing bulb, you should turn off or unplug the lamp and you must wait until it is cool as bulbs get hot quickly.

9. The safety instructions appearing in this manual are not meant to cover all possible conditions that may occur. It

must be understood that common sense, caution and care must be used with any electrical products.

IMAGE FOR FINISHED PRODUCT：

TOOLS REQUIRED (NOT INCLUDED):

Before doing assembly and installation please prepare the needed tools as below picture

Phillips head, flat blade

Ladder

Electrical

Pliers

Wire cutter / Striper

screwdriver

Page: - 1 - / 3

PAGE 1
Item Number: A03355 WARNING (To reduce the risk of fire, electric shock, or injury to persons): 1. We suggest installation by a licensed electrician. 2. Please read the instruction carefully and save it as you may need it at later time. 3. Before you start, NEVER attempt any work without shutting off the electricity until the work is done. A). Go to the main fuse, or circuit breaker, box in your home. Place the main power switch in the “OFF” position. B). Place the wall switch in the “OFF” position. 4.
PAGE 2
PARTS TYPE & QTY INCLUDING: (A) Green ground screw (1) (B) Mounting plate (1) (E) Canopy (1) (F) Threaded ball (2) (G) Loop (2) (H) Quick link (2) ( I ) Chain (1) (J) Lid（1） (K) Glass shade（1） (L) Screw (1) ACCESSORIES & QTY ENCLOSED: (C)Plastic Wire Connectors (3) (D) Mounting screw (2) ASSEMBLY & INSTALLATION INSTRUCTIONS: 1. Carefully remove the fixture from the carton and check that all parts and accessories are included as shown in the above illustration 2.
PAGE 3
Make installation Step B1:Unscrew the threaded balls (F) from canopy (E)then gently remove the moungting plate (B) Step B2:Attach the mounting plate (B) to outlet box with mounting screws (D) Step B3: Thread the glass shade (K) onto the lid(J) till tight then tighten with a screw (L). Install bulb (Not included. Please do not exceed the maximum capacity recommended on the socket.) Step B4: Make wire connections Connect wires as below wires connecting shown.