Product Info
Table Of Contents
- 1. Introduction
- 2. APPLICABLE MODULE
- 3. Additional Regulatory Conformance Testing and/or Submissions Required by the Integrator
- 4. Compliant/Allowable Tx Power Settings
- 5. Allowable Antennas to use with the Radio Module
- 6. Antenna Placement and RF Safety
- 7. Simultaneous Transmission with other Integrated or Plug-in Radios
- 8. Module May Not Be Installed by End Users
- 9. REQUIRED LABELING ON THE OUTSIDE OF THE HoST
- 10. REQUIRED LABELING ON THE MODULE
- 11. REQUIRED REGULATORY WORDING FOR End USER MANUAL / INSTALLATION MANUAL
- 11.1 FCC Requirements for End User Manual / Installation Manual
- FEDERAL COMMUNICATIONS INTERFERENCE STATEMENT
- FCC RF Exposure Requirements:
- 11.2 Industry Canada Requirements for End User Manual / Installation Manual
- Industry Canada Statements
- Radiation Exposure Statement
- Déclaration d'exposition aux radiations
- 12. OEM Integrator Checklist
Open-Q 835 µSOM Modular Certification TechNote77 OEM Integrator Guide
Rev. 1.1
4
Copyright Intrinsyc Technologies Corporation
5. ALLOWABLE ANTENNAS TO USE WITH THE RADIO MODULE
The module is certified for use with certain antennas as described in this section.
Allowed Antenna Types:
1. Dipole antenna
Table 1 Allowed Maximum Gain (dBi) Dipole, Including Cable Loss
2.4~2.5GHz
3.32
4.9~5.8GHz
6.11
The required antenna impedance is 50 ohms.
Use of other antenna types or the same type of antenna but with higher gain than listed
above is not allowed without additional testing and appropriate FCC or IC approval.
Use of a similar antenna may only require a C1PC to confirm the performance for SAR is
the same or better (i.e. lower) but only an equivalent antenna can be used without any
additional testing.