Product Info
Table Of Contents
- 1. Introduction
- 2. APPLICABLE MODULE
- 3. Additional Regulatory Conformance Testing and/or Submissions Required by the Integrator
- 4. Compliant/Allowable Tx Power Settings
- 5. Allowable Antennas to use with the Radio Module
- 6. Antenna Placement and RF Safety
- 7. Simultaneous Transmission with other Integrated or Plug-in Radios
- 8. Module May Not Be Installed by End Users
- 9. REQUIRED LABELING ON THE OUTSIDE OF THE HoST
- 10. REQUIRED LABELING ON THE MODULE
- 11. REQUIRED REGULATORY WORDING FOR End USER MANUAL / INSTALLATION MANUAL
- 11.1 FCC Requirements for End User Manual / Installation Manual
- FEDERAL COMMUNICATIONS INTERFERENCE STATEMENT
- FCC RF Exposure Requirements:
- 11.2 Industry Canada Requirements for End User Manual / Installation Manual
- Industry Canada Statements
- Radiation Exposure Statement
- Déclaration d'exposition aux radiations
- 12. OEM Integrator Checklist
Open-Q 835 µSOM Modular Certification TechNote77 OEM Integrator Guide
Rev. 1.1
8
Copyright Intrinsyc Technologies Corporation
10. REQUIRED LABELING ON THE MODULE
10.1 FCC and Industry Canada Labelling on the Module
The OEM integrator must ensure that the FCC ID and IC number is affixed on the Module
or in a User/Installation Manual along with other country certification numbers and logos as
described herein.
Note: the original Module manufacturer may affix regulatory labeling at time of Module
manufacturing. However, the OEM integrator must ensure that Module labeling is complete,
correct, and applicable for all the countries to which the host system is to be imported,
marketed, or sold.
11. REQUIRED REGULATORY WORDING FOR END USER
MANUAL / INSTALLATION MANUAL
11.1 FCC Requirements for End User Manual / Installation Manual
The OEM integrator must provide instructions in the end user manual how to retrieve the
module FCC ID for host devices using electronic labeling (for example an integrated
display) in lieu of a physical label or nameplate to meet the labelling requirements of
Industry Canada (Refer to FCC KDB 784748 D02 e labeling document for guidance).
The OEM integrator must include text in the end user manual meeting the regulators’
requirements. When the module is installed inside another device, the user manual of that
device must contain the statements and warnings below (text in red font must be replaced):
FEDERAL COMMUNICATIONS INTERFERENCE STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This product does not contain any user serviceable components. Any unauthorized product
changes or modifications will invalidate warranty and all applicable regulatory certification
and approvals, including authority to operate this device.
FCC Part 15 Digital Emissions Compliance
We [System Manufacturer Name, Address, Telephone], declare under our sole
responsibility that the product [System Name] complies with Part 15 Rules. Operation is