User's Manual

32 LS420 Universal User Manual V2.91 2003-01-21.doc
Step 6.
Grip the antenna by the base of the black
plastic sheathing and pull it straight out of the hole in
which it is seated. Place the old antenna aside.
Step 7.
Slide the white nylon hex bolt to the middle of
the length of the new antenna.
Step 8.
Coat the exposed metal foot of the new an-
tenna with an electrical insulating compound by care-
fully inserting it in the mouth of the compound tube.
Step 9.
Hold the new antenna by the black
plastic sheathing and guide it through the
hole in the sensor box. Carefully seat the
antenna in its mating connector. When
the antenna is correctly seated, pulling on
it will be met with light resistance.
Step 10.
Carefully re-thread, screw-in and
tighten the white nylon hex bolt to secure
the antenna in place.
Step 11.
Reinstall the sensor if necessary (if removed from the boom or jib, an angle sensor
will require re-calibration during the installation procedure, see the angle sensor installation
section of the user manual).
Step 12.Verify that the sensor functions properly.
White nylon hex bolt
Antenna
Sensor box
Antenna receptacle