Owner's manual

SC-1200 Quick Start Guide

SCSC

SC-

-1200 Quick Start Guide

1200 Quick Start Guide1200 Quick Start Guide

1200 Quick Start Guide

Install LoadVUE first. This will install the drivers needed.

(You can also download the drivers from

http://www.ftdichip.com/Drivers/CDM/CDM20814_Setup.exe

Simply download the .exe file and double-click to run it). This location might

have changed since this document was created. If you have problems

downloading, please check http://www.ftdichip.com/Drivers/VCP.htm

Plug all the load cells to SC-1200’s sensor ports. (The picture shows 9).

Plug in the power supply module to DC-IN and power up. Verify SC-1200’s

Green LEDs are on.

PAGE 1
SC-1200 Quick Start Guide SCSC-1200 Quick Start Guide Install LoadVUE first. This will install the drivers needed. (You can also download the drivers from http://www.ftdichip.com/Drivers/CDM/CDM20814_Setup.exe Simply download the .exe file and double-click to run it). This location might have changed since this document was created. If you have problems downloading, please check http://www.ftdichip.com/Drivers/VCP.htm Plug all the load cells to SC-1200’s sensor ports. (The picture shows 9).
PAGE 2
SC-1200 Quick Start Guide • If you have a Zigbee dongle, then your SC-1200 is wireless enabled. Physical connection to the computer is not required. Simply connect the Zigbee dongle to any of the computer’s USB ports. • If you do not have a Zigbee dongle, then you need to connect the SC-1200 directly to the computer. Connect SC1200-Master’s Uplink-Z port to the “RS422-to-USB” adapter (see below). Then plug the USB to an available port on your computer. The Windows OS will automatically assign a COM port.
PAGE 3
SC-1200 Quick Start Guide Each scale (load cell) is uniquely identified with a 8 character identifier, for example, M50.R00.C00.S01, M50.R00.C00.S02, ...S03, etc. This depends only on the port it is connected to, not to the scale itself.