Instructions / Assembly

Installation & Assembly Instructions
Please contact our Customer Service Division with any questions at:
30700 D Carter Street ∙ Solon, OH 44139 ∙ (P) 440.248.5480 ∙ [e-mail]
For a full line of products visit www.tritonproducts.com 2
bracket with preinstalled fasteners on rail end bracket. Partially install (4) ¼” bolts. Install bolts about half way
only. (Repeat steps 2 thru 4 for opposite end.)
5. (Refer to Figure 2-1 and 2-3) Installing Top Rail: Top rail will be positioned between corner angle brackets installed
at each end. Insert top rail from the underneath at slight angle and let set on bolts/fasteners of rail end brackets.
Using holes located on the top front edge of corner angle bracket insert truss head bolt through corner angle and
into corner threaded insert in top rail. (Repeat for all four top corners.)
6. Installation of internal center supports (Refer to Figures 1-1 parts call out, 2-1 and 2-4). Center support braces will
be placed inside of angle brackets and run the length of the cart. (figure 2-4) Each center support will be installed
with their flat edges without bolts facing up. From the end of each angle bracket install truss head bolt with center
point at each end. (Repeat for opposite end.)
7. (Figure 2-3) Tighten all (4) top end bolts used to attach corner angle brackets to rail end brackets at both ends.
8. (Figure 2-1) Pull handle installation: Locate the right corner angle bracket with the 4 extra holes at the top. Install
pull handle using ¼” tapered head bolts. (Note: handle will be positioned at end of tool cart that swivel casters will
be installed on.)
9. (Figure 1-2) Installation of Casters: Swivel casters will be installed on the end of tool cart with handle: With cart
on its side insert ¼” truss head bolts through caster mount plate and through holes in bottom tray, install ¼” flat
washer and secure in place using ¼” lock nut. Tighten securely after all 4 bolts have been installed. (Repeat for
each caster.)
10. Installation of Louvered Panels: Each 24”x48” panel has pre-drilled mounting holes that line up with the threaded
inserts on cart frame. Insert ¼” Truss bolt into each hole and hand tighten. Once all bolts have been installed on
the cart finish tightening with wrench and Philips head screwdriver.
Secure storage for all parts and fasteners can be achieved using the LocBin plastic
Hanging bins or any plastic hanging bin