Water Heater User Manual

1 Service (continued)

Service Mode Screen:

The Service Mode Screen allows the individual control

modules to override all other heat demands and operate at

a full fire condition for the purpose of combustion analysis.

Selection of the control module to be placed into Service

Mode is accomplished by pressing the SELECT button. The

control module being placed into Service Mode is shown in

the module box.

To place the unit into Service Mode, press the ON/OFF button

until ON is displayed. The control module will override all

other heat demands, however, all safeties will be active. If no

buttons are pressed, the control module will automatically

revert back to its original state after the Max Service Time

delay has expired. The default setting for the Max Service

Time is 20 minutes. To take the control module out of Service

Mode, press the ON/OFF button until OFF is displayed.

Items that can be viewed and interacted with on the Service

Mode Screen are as follows:

• Blower Power Level Indicator - A blower is depicted on

the display with a power level indicator beside it. The

level will increase and decrease indicating the

approximate power level of the blower. The display box

underneath the indicator level will display the firing rate

of the control module.

• RPM’s - The blower motor rpm that the control module

is requiring of the blower.

• Plus and Minus Buttons - By pressing the plus or minus

button the rpm of the blower motor can be increased or

decreased.

• Flame Signal - The flame signal for the control module

will be displayed in dc microamps.

Time - The time is displayed in the upper right-hand corner of

the display. It is displayed in a 24 hour format. Reference the

night setback parameters on page 21 for information regarding

adjusting the date and time.

Status button - Pressing this button displays the Status Screen.

this screen shows the current status of the Armor X2 water

heater. Reference page 12 for more information regarding this

screen.

Main button - Pressing this button displays the Main Screen.

From this screen, navigation to eight (8) other screens is

possible. Reference the Main Screen on page 16 for more

information regarding this screen.

Service Manual