Manual

Instructions for Model 2018

1. If you have a combination lock, it is easier to set the

combination before installing the safe.

2. Open console and remove the three screws in the floor of

console.

3. Place the front plate inside the console with the studs up but do

not attach fasteners.

4. Put the lid assembly in as shown in Fig 1, turn and pull up to top.

5. Install the flange nuts attaching the top to the front bracket to

hold the top in place.

6. With the lid open, place the back bracket to the top plate with

two flange nuts.

7. Insert the three provided screws to hold the front and rear

brackets to the console floor.

8. Now tighten the four flange nuts and you are done.

Enjoy your purchase.

Top Assembly Front Plate Rear Plate

See back for USB

Extension

installation.

PAGE 1
Instructions for Model 2018 1. If you have a combination lock, it is easier to set the combination before installing the safe. 2. Open console and remove the three screws in the floor of console. 3. Place the front plate inside the console with the studs up but do not attach fasteners. 4. Put the lid assembly in as shown in Fig 1, turn and pull up to top. 5. Install the flange nuts attaching the top to the front bracket to hold the top in place. 6.
PAGE 2
Use the included tool to remove the USB receptacle. 2. Unplug the cable from the rear. 3. Plug the included extension cable into the vehicle harness and route it Either inside the safe or outside, your preference. 1.