Full Product Manual

SECTION 3.5 15
3.5 Checking the Access Codes
OK Button
While in Programming Mode,
select “3CH” to check registered
Access Codes. If you are not in
Programming Mode, please see
Section 3.2 to enter Programming
Mode.
Active Access Codes will then be
displayed on the screen in
sequence from left to right, top to
bottom. In the example shown on
the left, the Access Code
displayed is 1 3 5 7 9 0 .
Rotate through the different Access Codes by touching any number on the screen.
To exit Check Access Code screen, simply press the OK button.
If there are no Access Codes registered in your smart
lock, Check Access Code mode will be invalid. The
default Access Code will not be shown on the display
keypad, and you will see the following screen shown to the
left instead.