Full Product Manual

SECTION 3.6 17
3.6 Adding a Fingerprint (Continued)
While in Programming Mode,
select “1AD” to add an Access
Code. If you are not in Program-
ming Mode, please see Section
3.2 to enter Programming Mode.
After pressing “1AD” press “FP”
to register a Fingerprint.
Upon pressing “FP”, you will enter Fingerprint Registration Mode and you will see a
green LED ring light up on the fingerprint panel on the exterior side of Lockly™ Secure
Plus / Pro.
Once you’re in Fingerprint Registration Mode you will see
two numbers displayed on keypad. The top number is your
Fingerprint Registration number, in this example to the
left, “1”. The bottom number will always start with a “6”.
You must successfully scan your fingerprint six (6) times for
it to properly register. Every time you scan your fingerprint,
the number on the bottom will change, starting from 6 - then
5, 4, 3, 2, 1, until the fingerprint is successfully registered.
Note: For reference, please keep a record of your finger-
print registration number to distinguish whom it was
registered to.