Full Product Manual

SECTION 3.6

3.6 Adding a Fingerprint (Continued)

NOTICE

Please make sure your fingers are clean from dirt and oils

before scanning your fingerprint. Make sure the sensor is

also clean by taking a soft cloth and wiping the surface.

Scan your finger by lightly placing your designated finger on the sensor until you hear a beep.

Lift your finger and repeat the process slowly until the digit “6” shown on the screen

becomes “1”. If you have successfully scanned and registered your fingerprint, you will hear

a long beep, and the Bluetooth icon will flash green.

PASS will show on the keypad and press OK to exit. If you did not successfully register your

fingerprint, FAIL will show on the keypad. If FAIL is displayed, press OK to return to the

previous screen to rescan your finger.

For instructions on scanning an optimal fingerprint, please proceed to Section 3.7.

OK Button