Use and Care Manual

While in Programming Mode,

select “1AD” to add an Access

Code. If you are not in Pro-

gramming Mode, please see

Section 3.2 to enter Program-

ming Mode.

After pressing “1AD” press

“FP” to register a Fingerprint.

Upon pressing “FP”, you will enter Fingerprint Registration Mode and you will see a green

LED ring light up on the fingerprint panel on the exterior side of Lockly™ Secure Plus / Pro.

3.6 Adding a Fingerprint (Continued)

SECTION 3.6

Once you’re in Fingerprint Registration Mode you will see

two numbers displayed on keypad. The top number is your

Fingerprint Registration number, in this example to the left,

“1”. The bottom number will always start with a “6”.

You must successfully scan your fingerprint six (6) times for it

to properly register. Every time you scan your fingerprint, the

number on the bottom will change, starting from 6 - then 5, 4,

3, 2, 1, until the fingerprint is successfully registered.

Note: For reference, please keep a record of your fingerprint

registration number to distinguish whom it was registered to.