Use and Care Manual

2.4 Factory Reset

SECTION 2.4

In order to restore the Lockly™ to factory default settings, you must have your “Initial Code”

available. The Initial Code can be found on the Initical Code Card that came with your smart

lock. (Was n the Quick Start Guide)

After you have the Initial Code ready, push the reset button on the back panel of the Lockly™

to perform your reset. See below to see which Reset Process applies for you. Once the smart

lock has been reset, all the data previously stored will be deleted.

2.5 Keypad Display Switch

The exterior keypad screen can be locked and

turned off by using the ON/OFF switch at the back

panel (interior) of the smart lock. When it is

switched off, people who are outside cannot enter

any access codes to unlock the door.

Reset Button

If Paired with App If Never Paired

Press Reset Button

for one (1) second

Open the Lockly™

smartphone app to

add your lock using

the Initial Code

Press Reset Button

for three (3) seconds