User's Manual

SECTION 3.2 9
3.2 Entering Programming Mode
To end Programming Mode, press the Program button anytime. Programming Mode
will automatically exit if the keypad is inactive for more than thirty (30) seconds.
After entering Programming Mode, you should see the screen
as displayed to the right on your Lockly Guard keypad. Follow
the following steps to add, delete, or check your Access Codes,
Fingerprints and RFID Cards.
Add Access Code, Fingerprint and RFID Card
ModeNumber
Delete Access Code, Fingerprint and RFID Card
Check Access Code
Program Button
To enter Programming Mode, remove the
battery compartment cover on the interior
side of the
Lockly Guard to expose the Reset
and
Program buttons.
Simply press the Program button to enter
programming mode.
Note: Program button will be disabled once
synced to a smart phone. Configure all settings
via synced smart phone. Access Codes previously
added by Programming mode will be cleared.