User's Manual

10 SECTION 3.3

If the two (2) Access Codes you entered does not

match, an error message will appear on the screen

(As shown to the right). Press OK to return to the

Programming Screen and try again. See Section 3.2

OK Button

3.3 Adding an Access Code

While in Programming Mode, select “1AD” to add an Access Code. If you are not

in Programming Mode, please see Section 3.2 to enter Programming Mode.

After pressing “1AD” press “Pd” to add an Access Code.

Enter your new 6 - 8 digit Access

Code and press when you are

finished. You will then re-enter the

code to confirm your new Access

Code.

Remember, just touch the digit you

need within the circle around each

3 numbers. There is no need to touch

the exact location of the number.

For example, based on the example

image to the right, if you need “1”,

you can touch the top button. For

“6”,

you would touch the second

button from the top.

If you have successfully entered your new Access

Code twice, you will see the new code displayed

here. In this example, we chose 654321. Press to

Confirm or to cancel.

To exit or cancel, you can always press or