User's Manual

12 SECTION 3.4 ~ 3.5
3.4 Deleting an Access Code (Continued)
There are two incidents where your Access
Code cannot be deleted.
• There are no Access Codes set. The factory
default Access Code cannot be deleted.
• There is only one (1) Access Code saved in
the smart lock. At least one code must be
registered. Please add another Access Code
before attempting to delete the existing
code.
No Access
Codes Set
Only one Active
Access Code
3.5 Checking the Access Codes
OK Button
Rotate through the different Access Codes by touch-
ing any number on the screen. To exit Check Access
Code screen, simply press the OK button.
While in Programming
Mode, select “3CH”
to check registered
Access Codes. If you
are not in Programming
Mode, please see
Section 3.2 to enter
Programming Mode.
Active Access Codes will
then be displayed on
the screen in sequence
from left to right, top to
bottom. In the example
shown on the right,
the
Access Code
displayed
is 1 3 5 7 9 0 .
If there are no Access
Codes registered in
your smart lock, Check
Access Code mode
will be invalid. The
default Access Code
will not be shown on
the display keypad,
and you will see the
following screen shown
to the left instead.