User's Manual

14 SECTION 3.6
NOTICE
Please make sure your fingers are clean from dirt and
oils before scanning your fingerprint. Make sure the
sensor is also clean by taking a soft cloth and wiping
the surface.
While in Programming Mode*, select “1AD” to add an Access Code. If you are not
in Programming Mode, please see Section 3.2 to enter Programming Mode.
After pressing “1AD” press “FP” to register a Fingerprint.
Upon pressing “FP”, you
will enter Fingerprint
Registration Mode and
you will see a green LED
ring light up on the
fingerprint panel on the
exterior of Lockly Guard.
3.6 Adding a Fingerprint (Continued)
You must successfully scan your fingerprint six (6) times for it to properly register.
Every time you scan your fingerprint, the number on the bottom will change,
starting from 6 - then 5, 4, 3, 2, 1, until the fingerprint is successfully registered.
Note: For reference, please keep a record of your fingerprint registration number
to distinguish whom it was registered to.
* Only works when lock is not paired with a smart phone device.
Once you’re in Fingerprint
Registration Mode you
will see two numbers
displayed on keypad.
The top number is your
Fingerprint Registration
number, in this example
to the top, “1” . The
bottom number will
always start with a
“6”.