User's Manual

SECTION 3.6 ~ 3.7 15
3.6 Adding a Fingerprint (Continued)
Scan your finger by lightly placing your designated
finger on the sensor until you hear a beep. Lift your
finger and repeat the process slowly until the digit “6”
shown on the screen becomes “1”. If you have
successfully scanned and registered your fingerprint,
you will hear a long beep, and the Bluetooth icon will
flash green.
PASS will show on the keypad and press OK to exit. If
you did not successfully register your fingerprint, FAIL
will show on the keypad. If FAIL is displayed, press OK
to return to the previous screen to rescan your finger.
For instructions on scanning an optimal fingerprint,
please proceed to Section 3.7.
OK Button
The fingerprint sensor equipped in Lockly
Guard is loaded with powerful fingerprint
algorithms to extract quality features from
fingers, even in poor conditions. Placing
your finger on the sensor correctly helps
consistency in fingerprint recognition.
The following directions and tips will guide
you on how to scan an optimal fingerprint
image.
3.7 Fingerprint Scanning Directions
Position your finger on the
center of the sensor
Sensor
Core