User's Manual

SECTION 4.8 27
4.8 Rain Mode
Like other digital electronic products water can trigger to activate the touch-
screen and fingerprint sensor which may cause the batteries to drain. To protect
the lock and extend battery life, you can setup your
Lockly Guard to enter Rain
Mode to shut off keypad and fingerprint reader whenever rain or water is detect-
ed.
Activate this feature on the
LocklyPro app. While you are within the Bluetooth
range or remotely connected thru Wi-Fi hub (Secure Link), go to Settings > Rain
Mode and toggle the button to turn ON.
When RAIN MODE is ON, the keypad,
fingerprint sensor and RFID reader cannot
be used. Unlock via LocklyPro App, or
physical key. Rain Mode auto exits every
30-mins and re-enters if water or rain is
still present.
If you are using the LocklyPro app, you
will be notified when Lockly Guard entered
rain mode and it will be recorded in your
access history.
IMPORTANT
If you have not yet connected your device to
LocklyPro App, follow below steps to activate
the rain mode feature:
RAIN MODE ON
1. Long press to enter fixed
digit keypad.
2. Enter access code +234+ .
3. You will hear a short beep and
Bluetooth
indicator flashes green
once Rain Mode is ON.
example: 135790 + 234 +
RAIN MODE OFF
1. Long press to enter fixed
digit keypad.
2. Enter access code +890+ .
3. You will hear a long beep and
Bluetooth indicator flashes green
once Rain Mode is OFF.
example: 135790 + 890 +