User's Manual

8 SECTION 3.2 ~3.3
3.2 Entering Programming Mode
*Activation Code card is attached to this user manual page cover. Store it for
future use. Once you have registered your lock on the Lockly app, you have the
option to save it on the PIN Genie Vault. To access details for future use, check
your account information and go to PIN Genie Vault.
To end Programming Mode, press the Program button anytime. Programming Mode
will automatically exit if the keypad is inactive for more than thirty (30) seconds.
Bluetooth Activation
ModeNumber
To enter Programming Mode, remove the
battery cover on the bottom of the Lockly
Guard to reveal the program buttons.
Short press the program button to enter
programming mode. Enter administrator
fingerprint, RFID card, activation code* or
administrator access code (the initial admin-
istrator password is 123456) then tap
Program Button
3.3 Pairing to a New Mobile Device
Pair with Bluetooth
While in Programming Mode, select “BL” to pair a new smart phone. If
you are not in Programming Mode, please see Section 3.2 to enter
Programming Mode.
After pressing “BL”, the BL icon will flash and you will here short beeps.
You need to wait and allow the pairing of new devices.
You will hear long beep and the green light will be on if the pairing is
successful. You will here 3 short beeps and the red light will be on if
pairing is unsuccessful. You will need to reenter the programming
mode, then Bluetooth pairing mode"BL" to re-pair the device.