User's Manual

SECTION 4.7 23
4.7 Rain Mode
Like other digital electronic products water can trigger to activate the touchscreen
and fingerprint sensor which may cause the batteries to drain. To protect the lock
and extend battery life, you can setup your Lockly Guard to enter Rain Mode to shut
off keypad and fingerprint reader whenever rain or water is detected.
Activate this feature on the LocklyPro app. While you are within the Bluetooth range
or remotely connected thru Wi-Fi hub (Secure Link), go to Settings > Rain Mode and
toggle the button to turn ON.
When RAIN MODE is ON, the keypad,
fingerprint sensor and RFID reader cannot be
used. Unlock via LocklyPro App, or physical
key. Rain Mode auto exits every 30-mins and
re-enters if water or rain is still present.
If you are using the LocklyPro app, you will
be notified when Lockly Guard entered rain
mode and it will be recorded in your access
history.
IMPORTANT
If you have not yet connected your device to
LocklyPro App, follow below steps to activate the
rain mode feature:
RAIN MODE ON
1. Long press to enter fixed
digit keypad.
2. Enter access code +234+ .
3. You will hear a short beep and
Bluetooth
indicator flashes green
once Rain Mode is ON.
example: 135790 + 234 +
RAIN MODE OFF
1. Long press to enter fixed
digit keypad.
2. Enter access code +890+ .
3. You will hear a long beep and
Bluetooth indicator flashes green
once Rain Mode is OFF.
example: 135790 + 890 +