User's Manual

SECTION 2.5 5
When the battery is in seriously low condition, Lockly Guard will make continuous beep-
ing sounds in addition to the flashing low battery icon on the touch screen.
You should
replace batteries immediately to avoid your smart lock from shutting down.
When your smart lock low-battery warning alert finally dies, you will have 3 chances to
unlock your smart lock either by a password, APP or fingerprint. If the unlock was
successful, the low-battery warning alert will be on for 1 minute. After which, the
smart lock will go to dead-battery mode and will lock auto lock in 5 seconds and the
screen will display a low-battery icon.
Your Lockly will automatically detect
battery polarity. So hold your 9V battery
lead in place against bottom of the
Lockly to temporarily activate the screen
to enter your Access Code. Be sure to
hold the 9V battery against the contact
points located at the bottom of the lock
until you have successfully unlocked your
door with your Access Code. Once
unlocked, batteries should be replaced
immediately.
2.5 Low Battery
Dead
Battery
Condition Indicator Solution
Low
Battery
Replace batteries immediate-
ly
to avoid battery failure.
Lockly Guard can still operate
up to 300 cycles in low battery
condition.
When there is no
display and sounds;
and screen is non-
functional.
Replace batteries immediate-
ly. Supplied physical backup
keys can be used to unlock
the door. Alternatively, Use a
9V battery as shown below to
temporarily activate the lock.
Battery Icon on the
display keypad will
light up to indicate
low battery
Touchscreen
9V
alkaline
battery