User's Manual

34 SECTION 4.8
Like other digital electronic products water can trigger to activate the touchscreen and sensor which
may cause the batteries to drain. To protect the lock and extend battery life, you can setup your
Lockly to enter Rain Mode to shut off keypad and fingerprint reader whenever rain or water is detected.
Activate this feature on the Lockly app. While you are within the Bluetooth range or remotely connected
thru Wi-Fi hub (Secure Link), go to Settings > Rain Mode and toggle the button to turn ON.
If you have not yet connected your device to Lockly App,
follow below steps to activate the rain mode feature:
To reactivate fingerpint and keypad
access when your lock has entered
rain mode, lift the outdoor handle.
When RAIN MODE is ON, the keypad
and fingerprint sensor cannot be used.
Unlock via Lockly App, physical key .
Rain Mode auto exits every 30-mins
and re-enters if water or rain is still
present.
If you are using the Lockly app, you
will be notified when Lockly entered
rain mode and it be recorded in your
access history.
4.8 Rain Mode
IMPORTANT
RAIN MODE ON
1. Long press to enter fixed digit keypad.
2. Enter access code +234+ .
3. You will hear a short beep and Bluetooth
indicator flashes green once Rain Mode is ON.
RAIN MODE OFF
1. Long press to enter fixed digit keypad.
2. Enter access code +890+ .
3. You will hear a long beep and Bluetooth
indicator flashes green once Rain Mode is OFF.
example: 135790 + 234 +
example: 135790 + 890 +