User's Manual

7SECTION 2.6
2.6 Low Battery
When the battery is in seriously low condition, Lockly will make continuous beeping sounds in addition
to the flashing low battery icon on the touch screen. You should replace batteries immediately
to avoid your smart lock from shutting down.
When your smart lock low-battery warning alert finally dies, you will have 3 chances to unlock your
smart lock either by a password, APP or fingerprint. If the unlock was successful, the low-battery warning
alert will be on for 1 minute. After which, the smart lock will go to dead-battery mode and will lock
auto lock in 5 seconds and the screen will display a low-battery icon.
Dead Battery
Condition Indicator Solution
Low Battery
NOTE: You cannot reset your lock when the battery is low.
Battery Icon on the display
keypad will light up to indicate
low battery.
Replace batteries immediately to
avoid battery failure. Lockly can
still operate up to 300 cycles in low
battery condition.
When there is no display
and sounds; and screen is
non-functional.
Replace batteries immediately.
Supplied physical backup keys
can be used to unlock the door.
Alternatively, use a 9V battery as
shown below to temporarily
activate the lock.
Your Lockly will automatically detect battery polarity.
So hold your 9V battery lead in place against bottom
of the Lockly to temporarily activate the screen to
enter your Access Code. Be sure to hold the 9V
battery against the contact points located at the
bottom of the lock until you have successfully unlocked
your door with your Access Code. Once unlocked,
batteries should be replaced immediately.
+ -
9V Battery