Installation Guide

4.1
4.3
4.4
Peel paper layer OFF the Adhesive
tape and prepare for installation.
4.2
Install Spindle (C) with the holes
side into the base of the lock
and align the holes locate in
the 3 o’clock and 9 o’clock
position.
Insert Locking Pin (D) in to
the hole as shown above.
Lightly bend Locking Pin (D) so it’s locked into place
from moving as shown. We recommend using pliers.
After you finshed bending the locking pin, turn the handle
to make sure it turns freely and nothing is obstructed.
D
STEP 4: PREPARING LOCK FOR INSTALLATION
If you drilled a hole in Step 1, use Slotted Barrel Extension (U) and securely tighten with a flat head screwdriver
by turning it clockwise onto the lock. If you did not drill a hole in step 1, you can leave this pole removed.