User's Manual

While in Programming Mode*,

select “1AD” to add an

Access Code. If you are not

in Programming Mode,

please see Section 3.2 to

enter Programming Mode.

After pressing “1AD” press

“FP” to register a Fingerprint.

Upon pressing “FP”, you will enter Fingerprint Registration Mode and you will see a green

LED ring light up on the fingerprint panel on the exterior side of Lockly Secure Plus / Pro.

3.6 Adding a Fingerprint (Continued)

SECTION 3.6

Once you’re in Fingerprint Registration Mode you will see two

numbers displayed on keypad. The top number is your

Fingerprint Registration number, in this example to the left,

“1”. The bottom number will always start with a “6”.

You must successfully scan your fingerprint six (6) times for it to

properly register. Every time you scan your fingerprint, the

number on the bottom will change, starting from 6 - then 5, 4,

3, 2, 1, until the fingerprint is successfully registered.

Note: For reference, please keep a record of your fingerprint

registration number to distinguish whom it was registered to.

*Only works when lock is not paired with a smart phone device.