User's Manual

SECTION 3.2

3.2 Adding a Fingerprint (Continued)

Scan your finger by lightly placing your designated finger on the sensor until you hear a beep. Lift

your finger and repeat the process slowly until the digit “6” shown on the screen becomes “1”.

If you have successfully scanned and registered your fingerprint, you will hear a long beep, and

the Bluetooth icon will flash green.

PASS will show on the keypad and press OK Button to exit. If you did not successfully register

your fingerprint, FAIL will show on the keypad. If FAIL is displayed, press OK Button to return to

the previous screen to rescan your finger.

For instructions on scanning an optimal fingerprint, please proceed to Section 3.3.

OK Button

NOTICE

Please make sure your fingers are clean from dirt and oils before scanning

your fingerprint. Make sure the sensor is also clean by taking a soft cloth

and wiping the surface.