User's Manual

SECTION 4.8 25
Like other digital electronic products water can trigger to activate the touchscreen and fingerprint
sensor which may cause the batteries to drain. To protect the lock and extend battery life, you can
setup your Lockly to enter Rain Mode to shut off keypad and fingerprint reader whenever rain or
water is detected.
Activate this feature on the Lockly app. While you are within the Bluetooth range or remotely con-
nected thru Wi-Fi hub (Secure Link), go to Settings > Rain Mode and toggle the button to
turn ON.
If you have not yet connected your device to Lockly App, follow below steps to activate the rain
mode feature:
When RAIN MODE is ON, the keypad,
RFID card and fingerprint sensor cannot
be used. Unlock via Lockly App, physical
key, or voice control with Amazon
Alexa or Google Assistant-enabled
devices. Rain Mode auto exits every
30-mins and re-enters if water or rain
is still present.
If you are using the Lockly app, you
will be notified when Lockly entered
rain mode and it will be recorded in
your access history.
4.8 Rain Mode
RAIN MODE ON
1. Long press to enter fixed digit keypad.
2. Enter access code +234+ .
3. You will hear a short beep and Bluetooth
indicator flashes green once Rain Mode is ON.
RAIN MODE OFF
1. Long press to enter fixed digit keypad.
2. Enter access code +890+ .
3. You will hear a long beep and Bluetooth
indicator flashes green once Rain Mode is OFF.
example: 135790 + 234 +
example: 135790 + 890 +
IMPORTANT