User's Manual

3.2 Entering Programming Mode

SECTION 3.2

Program Button

Add Access Code

ModeNumber

Delete Access Code

View Access Code

To enter Programming Mode, remove

the battery compartment cover on the

interior side of the Secure to expose the

Reset and Program buttons (See page 8).

Simply press the Program button to

enter programming mode.

Note: Program button will be disabled

once synced to a smart phone. Configure

all settings via synced smart phone.

Access Codes previously added by

Programming mode will be cleared.

To end Programming Mode, press the Program button anytime.

Programming Mode will automatically exit if the keypad is inactive for more than

thirty (30) seconds.

After entering Programming Mode, you should

see the screen as displayed to the right on your

LOCKLY

keypad. Follow the following steps to

add, delete, or check your Access Codes.