Installation Guide

5.1: First install 3 of the 4 batteries. Before installing the last
battery, press and hold the PROGRAM button while
installing the last battery until you hear a beep from Lockly.
Lockly will then perform a self check and the keypad screen
will start to initiate. This self check will automatically determine
and set your door lock to a left open or right open door.
5.2:
After you checked that the lock manually lock and
unlock and deadbolt moves smoothly, Install the battery
cover with screw (H) and fastened.
The self-check process is very important step to ensure the installation is done properly.
After the lock finished the self-check, manually lock and and unlock your door by using the
thumb turn and the key to make sure the deadbolt moves smoothly. If you feel that there is
a tight tension while you are turning, it means that the lock may have not been installed
straight. Go back to Step 2 and re-install the lock.
To check if your lock was installed correctly, manually unlock your door by using the thumb
turn, then brush your hand across the screen on the outside. Your lock should lock the
deadbolt. If your lock automatically unlocks after it has been locked, it means that your
lock was installed incorrectly - proceed to Step 2 to make sure your lock was installed with
the deadbolt extended and the torque blade was inserted vertically while the deadbolt
was extended.
STEP 5. INSTALLING BATTERIES
+
-
+
-
+
-
+
-
PROGRAM
RESET