Installation Guide

3: Once self-check completes ensure the
lock operates smoothly by manually locking
and unlocking the door using the thumb
turn on the interior assembly. The deadbolt
should operate smoothly without any
interference or binding. If necessary, repeat
step 2 and ensure that (a) the deadbolt
was extended and (b) the torque blade
was inserted vertically while the deadbolt
was extended.
4: Once self-check is complete, install the
battery cover (H) and secure with screw on
top (do not over tighten).
1: With door open and deadbolt fully extended,
place ribbon inside compartment and insert 4
batteries (note correct -/+ polarity).
2: After all batteries are installed, PRESS and
HOLD the program button for 10S. The lock will
automatically start self-check (release program
button once check starts). The self-check process
determines right or left swinging door and is very
important to ensure correct installation.
IMPORTANT: if lock is not properly installed it will
open and close repeatedly.
10
INSTALLING BATTERIES
PRESS
& HOLD
Step 4
1
2
3
4