User's Manual

SECTION 3.110
3.1 Configuring Access
The Default Access Code is
NOTICE
1 2 3 4 5 6
The Default Access Code is
NOTICE
1 2 3 4 5 6
How to Use the Keypad
There are a total of five (5) buttons on the
keypad as shown in the example image to
the left. The numbers in each button may
differ than what is shown on your device
than what is displayed here.
To enter your required digit, just simply press
the circle where your number is shown. You
do not need to press the actual number as
anywhere within the circle will suffice.
The button on the bottom is the OK button.
You will be pressing this button when you are
done entering your Access Code.
Your new Lockly Access Code can be any combination of 6 to 8 digits.
Once a new Access Code is entered, the Default Access Code of 123456
would be deleted.
A Maximum of 8 sets of Access Codes can be stored for use.
Your new Lockly Access Code can be any combination of 6 to 8 digits.
Once a new Access Code is entered, the Default Access Code of
123456 would be deleted. A maximum of 16 sets of Access Codes can
be stored for use at any given time. To add more than 16 sets of
Access Codes, you must delete an existing Access Code before dding
a new code. If you're not using the APP, you can store up to 18 sets of
Access Code.
OK Button
3.1 Configuring Access