User's Manual

SECTION 3.618
Once you’re in Fingerprint Registration Mode
you will see two numbers displayed on keypad.
The top number is your Fingerprint Registration
number, in this example to the left, “1”. The
bottom number will always start with a “6”.
You must successfully scan your fingerprint six (6)
times for it to properly register. Every time you
scan your fingerprint, the number on the
bottom will change, starting from 6 - then 5, 4, 3,
2, 1, until the fingerprint is successfully registered.
Note: For reference, please keep a record of
your fingerprint registration number to distinguish
whom it was registered to.
While in Programming Mode, select “1AD” to add an Access Code. If you
are not in Programming Mode, please see Section 3.2 to enter Programming
Mode.
After pressing “1AD” press “FP” to register a Fingerprint.
Upon pressing “FP”, you will enter Fingerprint Registration Mode and you will
see a green LED ring light up on the fingerprint panel on the exterior of
Lockly.
3.6 Adding a Fingerprint (Continued)