User's Manual

5.1 The Interior assembly comes with
pre-installed wired door sensor for right
swing doors with 2 ¾" (70mm) backset*.
Discard the excess part (e) for doors with
2 ⅜" (60mm) backset as shown below:
5.2 For left swing doors, re-route the door
sensor wire through the side channel as
shown below. Use foam pad (f) to secure
the wire. Discard the excess part (e) for
doors with 2 ⅜" (60mm) backset as
shown below:
*Backset - measure the distance of the door edge to the center of the door hole.
DO NOT INSTALL THE SENSORS YET >
EVA
P P
f
STEP 5. PREPARING DOOR SENSOR FOR INSTALLATION
1
2
3