User's Manual

7.1: While the door is open and deadbolt is
extended, place the ribbon inside the
compartment and insert only 3 batteries at
the bottom layer with correct polarities.
7.2 Press and hold the program button
before inserting the 4th battery. The lock will
automatically do a self-check. The
self-check process is very important to
ensure the installation is done properly.
After the lock finished the self-check, do the 2-steps below to ensure your lock is properly
installed:
STEP 7. INSTALLING BATTERIES
7.3: After you checked that the lock
manually lock and unlock properly and
deadbolt moves smoothly, continue to
install the last 4 batteries on the top
layer of the battery compartment.
7.4: Install the Battery Cover (I) and
secure with screw.
1. Manually lock and unlock your door by
using the thumb turn and the key to
make sure the deadbolt moves smoothly.
If you feel that there is a tight tension
while you are turning, it means that the
lock may have not been installed
straight. Go back to Step 2 and re-install
the lock.
IMPORTANT: If your lock is not properly
installed, it will open and close repeatedly
at times and/or it will reduce battery life.
2. Brush your hand across the screen on
the outside. The lock will close. If your lock
automatically unlocks after it has been
locked, it means that your lock was
installed incorrectly. Go back Step 2 to
make sure your lock was installed with the
(a) deadbolt extended and (b) the
torque blade was inserted vertically while
the deadbolt was extended.
PRESS & HOLD
1
2
3
4
5 6 7 8
5 6 7 8