User's Manual

6
Program Button
RESET
2.6 Program |Pairing Button
In case you need to re-pair your lock to your Vision Connect hub, follow the steps below:
1. Slide up the battery cover and press the Program button once until the screen
shows the Pairing button (PA).
2. Press PA button and wait till you hear 2 short beeps. (You might have to wait up to
30 seconds)
3. On the Vision Connect hub, press the reset button 3x with a pin or paper clip. You
will hear a long beep, if pairing is successful.
Repeat steps 1, 2 & 3, if you hear 3 short beeps.
SECTION 2.6