Installation Instructions

5SECTION 4.124
OK Button
Lockly Guard Smart Lock can be unlocked using multiple ways - via your stored
Access Code, registered fingerprint, smartphone with Bluetooth, the physical key
supplied with your lock, or voice.
Lock your Lockly Guard by pressing the OK Button or by brushing your hand across
the screen anytime when the door is closed. The smart lock will also auto-lock
after unlocking based on your set auto-lock settings.
You may toggle between two types of keypad displays to enter your Access
Code. The fixed digit version and the PIN Genie version (Recommended). Press
and hold the OK Button for 3 seconds to toggle back and forth between the two
keypads. (Sample display shown only)
Slide your hand across the screen to activate
the keypad.
Enter your 6 to 8 digit Access Code followed
by the OK button. Press OK anytime to reset if
you entered the wrong digit.
If the Access Code entered is correct, the
door will unlock. If the Access Code entered
is incorrect, lockly will flash red light.
Three consecutive wrong attempts will put Lockly in
“Safe Mode”. (See Section 4.5)
Hold OK Button (3 sec)
PIN Genie Fixed Digit
NOTICE