Installation Instructions

SECTION 4.5 27
Lockly Guard will enter Safe Mode when three (3) consecutive wrong Access
Codes are entered within 5 minutes. A 15 second video will be recorded once the
lock entered into Safe Mode. When in Safe Mode, the lock status icon will start
to flash.
To disable Safe Mode, you must unlock the door using the correct fingerprint or
enter the correct Access Code twice in a row. Activate the keypad by pressing
and holding for 3 seconds.
Once the screen is activated, enter the correct Access Code carefully twice,
pressing after every time.
If you enter the wrong code, the keypad will then be disabled for 10 minutes.
You will see a “10” on the screen, notifying the number of minutes that the
keypad is disabled for. After 10 minutes, you may attempt to enter the correct
Access Code to unlock the door. After the second incorrect attempt to unlock
the lock with the wrong Access Code, Lockly will disable the keypad for 20
minutes, displaying a “20” on the screen. After the third wrong attempt to unlock
the door with the correct Access Code, the screen will be disabled for 30
minutes. (Example A and Example B above).
In order to conserve power, the countdown prompt will
only be displayed for 3 seconds. You can reactivate the
screen by sliding your hand across the screen.
Countdown Prompt
(Displayed in Minutes)
Will start with 10 and
countdown until 0.
NOTICE
4.5 Safe Mode - Overview