Installation Guide

Step 2
INSTALLING EXTERIOR ASSEMBLY (B)
Check the exterior assembly for alignment between door hole and deadbolt.
Make sure torque blade is in the vertical position with the deadbolt extended.
Place assembly and torque blade through the deadbolt slot and guide connection
cables through the cross-bore hole under the deadbolt as shown. Complete
mounting by aligning and securing until flush to exterior door surface.
B
EXTERIOR VIEW
3
Door edge side view
2-3/4" (70mm)
Door edge side view
2-3/8 "(60mm)
Interior
Interior
LEFT SWING DOOR
RIGHT SWING DOOR
LEFT SWING DOOR
RIGHT SWING DOOR
Interior
Interior
Observe the correct position of the cable to ensure it is according to your door
opening orientation (Left / Right Swing) and Backset size (60mm/70mm).
During installation, DO NOT hammer the deadbolt and/or its metal plate to
avoid damaging the built-in sensor.
1.4
2
Vertical
B
3
Under
Extended
1
When installing the
exterior assembly,
please do not insert
a physical key.