Use and Care Manual

Ensure battery has been fully charged.

Install battery and start self-check

Install battery as shown.

Perform self-check (skip if done)

Immediately hold the red program

button for 4 seconds. The lock will

perform a self-diagnostic by extending

and retracting the deadbolt multiple

times.

Open the Lockly app and tap (+) to

add a new device. Locate your Lockly

model and follow in-app instructions

to continue setup.

After 10 minutes of powering on, the Bluetooth connection will be disabled, preventing

pairing with the Lockly or Home app. To re-enter Pairing Mode, reinstall the battery or

press the Program button. You can also reactivate Bluetooth pairing by tapping the

"BL" in the circle on the keypad.