Installation Guide

PG 12PG 12
Congratulations, you have successfully installed your unit. Please proceed to
the OPERATING Guide to initialize the LS-60.
IMPORTANT: If you have labeled and connected your wires
and followed the correct HVAC setup, and your system still does
not operate,
contact technical support .
STATEMENT OF USE: This thermostat can be used with
3AA batteries, 24VAC (C wire), 24VAC adapter, heating
and cooling systems and also millivolt heating. It cannot
be used with line voltage systems. This thermostat is digital
and your desired heat or cool temperatures can easily
be set on the large touch screen with the +/- buttons. A
minimum 4 minute off time protects the compressor from
damage.
This thermostat runs on 3AA batteries. The LS-60 can be
externally powered with a power source rated from 12V
to 24V, AC or DC, at 300ma or greater. If used, connect
to the C and RH terminals (no polarity). The 24VAC “C” wire is the other side of the 24VAC heating
transformer and can be found where the other thermostat wires connect at the wall or at the furnace.
Do not use the common or ground side of the line voltage.
DAY
F
LINK
RADIO
TARGET TEMP
1
COOL
AUTO
PM
MODE
control
FAN
control