User Manual

8. INSTALL BATTERIES

9. CHANGE LEVER HANDING

Insert 4 AA Alkaline or Lithium batteries

and put the battery cover back on the

receiver module.

Do not use rechargeable (NiCD, NiHM,

LiPo, etc.) batteries or batteries with a

voltage rating of under/over 1.5v * Please

Note: Deadbolt model will not function

until door handing is programmed on the

lock (pg.8)

Be sure the levers are unlocked.

Insert the provided pin wrench

into the small hole on the neck

of lever and apply pressure to

depress the catch and pull out

the lever from the stem.

Follow the same steps to remove

interior lever and exchange the

position of inside and outside

levers.

Remove the cylinder from lever and insert it into opposite lever.

Then install the levers and make sure the small hole on the neck of lever aligns over

the catch perfectly. Rotate the levers to see if it operates well.

BATTERY

COVER