35 1-9/16" 1-3/8" 40 Fit here on door edge 45 Mark Ø1" (25.4mm) hole at center of door edge. 2" 1-3/4" 51 ELECTRONIC DEADB OLT LOCK 2 3 4 5 6 7 8 9 0 FOR BACKSET 60mm (2-3/8”) Ø54mm (2-1/8") 1325 S. Colorado Blvd.
WI-FI ELECTRONIC DEADBOLT INSTALLATION INSTRUCTIONS 3. Install Latch a. Insert the latch and ensure it is paralleled to the door face. Mark the outline of the faceplate, then take out the latch. The BACKSET is the distance between the center of cross bore and edge bore of the door. Adjustable latch fits both BACKSET of 2-3/8” (60mm) and 2-3/4” (70mm). Please follow the steps shown below for BACKSET adjustment. b.
5. Install Keypad Assembly 8. Adjusting Turn Piece a. Ensure the latch bolt must be retracted. Turn the turn piece to left for 45 degrees when it's right-handed door. Turn the turn piece to right for 45 degrees when it's left handed door. b. Please refer to the diagram below for Cylinder Installation. Place deadbolt against keypad with tailpiece in horizontal position inserted through hub of the latch. Turn Piece c. Pass the IC wire under the latch to the interior side of the door.
Programing Your Lock 1.Default Settings 1. The default User Code on the lock is 1234 2. The default Programing Code (PC) on the lock is 12345678 3. Please change both of these codes when first setting up the lock for security purposes. This can either be done through keypad programming (refer to Keypad Programming Functions section). 2.
Keypad Programming Functions Enable all user code Enter PC Auto-detect lock handing (Deadbolt Lock Only) Enter PC Mute Keypad 140 Note : If you have a lever lock you do not need to run this operation. For deadbolt locks, please run the door-handing identifying before doing anything else on your lock. Put your lock in the LOCKED position before running this function.
Detailed Lock Functionality 6. User Code 1.Battery Four AA(1.5V)Alkaline batteries. 2.Low Battery 1. The batteries should be changed immediately once you see the LED flashes in red and hear 6 beeps when press the LockState button. 2. All settings are retained in the memory and will not be affected even if the battery is completely dead. 3. The lock still can be operated by key even there is a power outage. 3. LED Indicator 1. LED flashes green once when successful operation. 2.
12. Lock the door The door will be locked by key, pressing the LockState/Enter button on the keypad from outside, by interior turn-piece, or from your online account. 13. Incomplete Door Closing / Opening 1. If the latch bolt is not extending/retracting completely when you try to lock/unlock the door via the keypad, you will see the LED flash red 3 times and hear 3 beeps (No alarm when it's in mute). The lock will reverse itself automatically in this case to the position it started in. 2.