Instructions / Assembly

1.4 Installing the Lock
Place the latch through the latch hole positioned
correctly for latching your door. Leave the latch
loose until both the front and rear mounts are
installed.
Place the front mount rubber gasket over the side
of the mount that will touch the door.
Place the front mount through the knob hole while
sliding the latch through the groove in the mount.
(see below).
When the front mount is in place, hold the back
mount rubber gasket against the back side of
the door and place the back mount over the
gasket and onto the stem protruding from the
front mount.
Secure the back mount to the front mount with
the screws provided. Ensure that the lock is
on straight and then screw the remaining
screw directly into the door. When the lock is
completely attached, screw the latch into the
side of the door.
2. PROGRAMMING
The LS-RDJ electronic code lock is
designed with 2 types of entry codes
that will open the lock:
1 Master Code and
9 User Codes
The master code can open the lock but
is also used to create, change and
cancel user codes. Each of the 9
available user codes can open the lock.
Both the master code and the user
codes can be made up of 1 to 13 digits.
It is important to note that the master
code MUST start with the digit “0”. The
factory preset master code is “0123”.
Similarly, each of the user codes can
only start with one of the remaining 9
digits. That is, there can be only one
code that begins with the digit “1”, only
one code that begins with the digit “2”
and so on up to the digit “9”.
2.1 Setting & Changing the Master
Code
To change the master code, enter the
existing master code (initially “0123” from the
factory) and press the “ON” button. You will
here a beep after which you can enter a new
master code and then press the “S” button.
Remember, the master code MUST begin
with the digit “0”. Your new master code
has now been saved in the lock.
2.2 Setting &Changing the User
Codes
To create a user code, enter the existing
master code (initially “0123” from the
factory) and press the “ON” button. You
will here a beep after which you can
enter a new user code and then press
the “S” button. Remember, user codes
can NOT start with the digit “0”. Your
new user code has now been saved in
the lock.
There are two ways to change an
existing user code. You can change
user codes by using the master code or
by using the user code that you would
like to change.
To change a user code using the master
code, enter the existing master code
(initially “0123” from the factory) and
press the “ON” button. You will here a
beep after which you can change a user
code to a new code that begins with the
same digit as the user code you want to
change. After entering the new code
press the “S” button. Remember, user
codes can NOT start with the digit “0”.
Your user code has now been changed
in the lock.
To change a user code using the user
code, enter the existing user code and
press the “ON” button. You will here a
beep after which you can change the
user code to a new code that begins
with the same digit as the old user code.
After entering the new code press the
“S” button. Remember, user codes
can NOT start with the digit “0” and
can only begin with the same digit as
the old user code. Your user code has
now been changed in the lock.