Manual

ManualsBrandsLOCKSTATE ManualsFor HomeLS-RDJ

The LS-RDJ comes standard with the

following features:

• 1 unique master code

• 9 unique user codes

• Low Battery Alarm

• External power capability

• Manual override keys

• Tamper-proof error function

• Easy installation

1. INSTALLATION

1.1 Lock Diagram

Below is a diagram of the LS-RDJ with

numbers indicating areas of function. These

numbers correspond with their description in

the box below:

1.2 Door Diagram

If you are installing the LS-RDJ in a

door with pre-drilled holes, the lock

will fit most standard doors. To

confirm that the lock will fit your door,

please verify the following

measurements:

1. Backset is either 2 3/4” or 2 3/8”

(backset is the measure from the edge of

the door to the center of the knob hole)

2. Door knob hole is 2 1/8”

3. Latch Hole is 7/8”

(see figure below)

1.3 Installing the Batteries

The battery case is located in the lower

half of the outside lock piece.

Remove the battery case by inserting

the small green screw driver through

the bottom hole of the back side of

the front mount (see below). As you

press the screw driver through the

hole the case will release from the

bottom of the mount. Place 4 AA

batteries in the case and replace the

case in the mount.

Fig. 1

Handle (Left handle or Right handle)

"S" key (setup key) for setting new codes

Green light indicating the lock is open

Socket for external power (6V)

Red light indicating the lock is not open

Digital keypad (digits 0-9)

"ON" key used for unlocking the lock

Emergency manual keys

Summary of content (3 pages)

PAGE 1
The LS-RDJ comes standard with the following features: • 1 unique master code • • • • • • 9 unique user codes Low Battery Alarm External power capability Manual override keys Tamper-proof error function Easy installation 1. INSTALLATION 1.1 Lock Diagram Below is a diagram of the LS-RDJ with numbers indicating areas of function.
PAGE 2
. PROGRAMMING 1.4 Installing the Lock Place the latch through the latch hole positioned correctly for latching your door. Leave the latch loose until both the front and rear mounts are installed. Place the front mount rubber gasket over the side of the mount that will touch the door. Place the front mount through the knob hole while sliding the latch through the groove in the mount. (see below).
PAGE 3
2.3 Canceling and Resetting Codes In order to cancel ALL existing user codes, enter the existing master code and then press the “ON” button. After you hear a beep press the digits “0000” and then press the “S” button. All user codes will then be canceled. If you need to reset the master code but you have forgotten the existing master code, remove the back mount from the door and find a small hole at the top of the door facing side of the back mount.