Use and Care Manual

To program, press the small black button through the access hole on the back of the
door using a pen. The yellow light will illuminate and you will have 10 seconds to enter
your personal (3 to 8) digit combination. You can use the same number multiple times
(Eg. 1-1-2-2) if desired. Press the button again to save the new combination. The yellow
light will go out and your personal combination has been set.
Close the door and push the latch up to lock the door. To test, enter your new
combination and the green light will go on. Push the latch down to unlock the door.
4. SECURITY NOTE
If the combination is entered incorrectly the yellow light will flash. If the combination is
entered incorrectly (3) consecutive times the keypad will automatically lock out for 30
seconds. If the incorrect combination is entered an additional (3) times the keypad will
lock out for (5) minutes before you can try the combination again.
5. TURNING THE KEYPAD SOUND OFF/ON
You can turn off or on the "Beep" sound of the keypad by pressing two buttons that are
at opposite corners from each other (1-4 or 2-3) at the same time.
6. SECURING THE SAFE
This safe has a mounting plate which allows you
to remove the safe. First remove the mounting
plate by loosening the thumb screw from inside
the safe. (figure 2)
Mount the plate in the desired location using the
appropriate hardware. Slide the safe on the
mounting plate and tighten the internal thumb
screw.
The safe can also be mounted permanently
using the (4) top or bottom mounting holes.
Remove the top hole plugs by pushing them out
from the inside of the safe. Mount the safe
through the top or bottom mounting holes using screws and washers. Use the opposite
mounting hole for screwdriver access. Reinstall the hole plugs in the top if the safe is
mounted using the bottom holes.